Eye Candy Gel Wax

Usage Instructions – Gel Wax

1. Area to be Waxed must be clean, dry and free from any oils and creams. Use Waxxxpress On Your Marks Pre Wax Skin Cleanser. Always test Wax on the inside of your wrist before use. Do not apply on warts, moles and broken or irritated skin.
2. You may begin by dipping Applicator into Wax, which should be the consistency of gel.
3. Apply Wax with the hair growth using an Eye Candy Contouring Stick, leaving one edge thicker to create a lip. Gel Wax should be applied in small, thick sections.
4. Hold skin taut and remove Wax by pulling in the opposite direction of hair growth.
5. For the perfect finish and to remove any Wax residue on the skin, we recommend you use Keep Calm and Waxxx Off After Waxing Oil and Body Icing. To clean equipment use Clean & Glo Wax Remover Citrus Clean.

Heating Instructions – Beads

1. Pour Wax Beads into the Metal Insert of a Wax Heater in stages, stirring in between until it melts. Do not overfill past ¾ full.
2. Heat Wax Beads on high for approximately 10 minutes, stirring regularly.
3. Regulate Heater to a medium setting or between dial 3-4 on a Big Dipper Wax Heater or approximately 140°For 60°C.
4. Dip Wax Applicator into Wax, at the correct consistency Wax should resemble gel and should sit on the end of the Applicator and be practically dripless. If Wax is moving, it is too hot. It is necessary to melt down Wax completely.
5. Top up Beads gradually after each use to maintain heat consistency, do not fill Insert past ¾ full and Wax should always be able to be stirred.

Warning

Low Wax temperature. This is a professional product for Salon use only. Patch test before use. If skin irritation occurs, cease use. Exceeding the recommended instructions may cause burns and/or injury.